Hi folks!
When I create a recovery drive it boots normal but when I create a repair disk it gets stuck at the Windows logo. When I finally take out the disk a BSOD is telling me that there was a drive error and I should check the connection. Both media have been created with the same system (1511). The repair disk is fully readable and Linux disks will boot so a hardware issue can be excluded.
I am just wondering what might be the cause of this phenomenon. It's not a big deal as I could always use the USB drive.
Thanks
When I create a recovery drive it boots normal but when I create a repair disk it gets stuck at the Windows logo. When I finally take out the disk a BSOD is telling me that there was a drive error and I should check the connection. Both media have been created with the same system (1511). The repair disk is fully readable and Linux disks will boot so a hardware issue can be excluded.
I am just wondering what might be the cause of this phenomenon. It's not a big deal as I could always use the USB drive.
Thanks